This is a 10-piece set of jewelry designing gravers. It has the following: carbide graver blank x2 #2/0 onglette #1 onglette square graver x2 flat graver x2 (sizes #42 and what appears to be #40 on the label of the other one) 120 degree graver #52 round graver Any gravers that only have one picture provided are sets of 2 where both gravers appear to be in the same condition. In some of the sets of 2, I took a picture of each graver because one looks brand new and the other has spots of rust along the shaft. All in all, they're in good, sharp condition.The cutting edges of the gravers are nice and clean. The oxidation on some of them only appears in little specs and could probably be cleaned or grinded off. I cleaned the rust off one of the gravers with just my finger tips and some dish soap and water. They've only been lightly used during a jewelry design and repair class. Only some of these gravers have ever even been used once. The others may as well have come straight from a GRS retailer because they've never been put to use. The gravers that I did use were only ever used on copper, silver, and fake training gold. The only application for which I used the gravers was to create prongs to hold embedded stones. The item "GRS Graver Set 10 pieces (Gravers for jewelry design and repair 10-pc)" is in sale since Tuesday, September 12, 2017. This item is in the category "Jewelry & Watches\Jewelry Design & Repair\Jewelry Tools\Engraving Tools".
The seller is "podrasky_holistics" and is located in Pinellas Park, Florida. This item can be shipped to United States.